How To Wire Occupancy Sensor And Motion Detectors

Wall swap has 2 wires, plus green floor screw for naked-copper floor wire. If occupancy change is rated single-pole and 3-means, then it can have yellow or blue wire in addition to purple wire proven in illustration. With the single-pole 3-method, the pink wire is capped for single pole installation. Use the blue or yellow wire to hook up with load (mild fan motor and so on). 1) Occupancy-inexperienced-wire connects to bare floor wire. 2) Single-pole switch being replaced has 2 wires. Take Single-pole switch wires and connect them to Occupancy-black-wire and Occupancy-crimson-wire. Select either light sensor for now. 3) In again of electric field are white wires twisted collectively and covered with wire connector. Connect Occupancy-white to these wires. 4) If electric field does not have white wires described above, then join Occupancy-white to naked floor. Occupancy change will work until you may have time to run extra White impartial wire from nearby outlet. 5) Turn on electricity, and activate occupancy switch. If occupancy light switch come on, Occupancy is wired appropriately. If lights do not come on, then reverse Occupancy-crimson and Occupancy-black wires.